S-MATE2 - control a switch remotely

[mtsaustralia]

Hi, i am trying to control a switch remotely that i can’t run power to. Is there a way to remotely activate the s-mate 2?

I know how to use the s-mate to control a mini4 or other device, however i want to do this in reverse, however the scene (smart scene) won’t allow me to do it this way. Any idea’s.

For more detail…. I am trying to remotely activate a medical x-ray unit from an offsite location. I was going to try use the s-mate to do it, as i can’t run power to the location, so the battery operation is ideal. If this doesn’t work, is there something else?

[dvashtag]

You can support me, if there are more of us, perhaps we will be heard earlier. I would also like to have a multi-contact controller on a battery for low-current circuits, which would be possible to connect to any means, to any contactors.

S-MATE 2 or S-MATE3 for low voltage

S-MATE 2 is a sensor, or more precisely an RF (e-WeLimk Remote) NC 3CH Sensor, through the contact of which the battery current flows, i.e. approx 3V. DIP switch Has two operating modes depending on the switch. My suggestion is that if this cannot be implemented on this board, then make S-MATE 3 as a separate device or add S-MATE GEN2 a switch from sensor mode to performer mode. By S-MATE 3 I meant precisely the actuator for monitoring low-current circuits, if this could be implemented in softw…