Hello,
The 1.20.0 update for ZBB-U has been released. Are there any known issues? After every update, we encounter serious problems. We’ve almost become afraid to update anymore.
Nothing has happened to me yet, the network status has improved, but they are only testing it with 7 devices on the network, a thermometer, light, 2 types of motion sensors and a water leak sensor. So far so good
Dangerous! I had 31 ZB devices online and connected. After the update I lost (disappeared) 21 devices and the rest which was online was only by their device name. Yesterday I reconnected all devices again. This morning I lost (they disappeared) them again. Only 2 are connected. Rebooting did not solve the problem. The ZB devices are gone!
I am really angry. Wasting my time and nerves.
Before this update it was working all the time. No problems.
Hello,
This is a very bad situation! Aren’t these updates supposed to make things better? Or are they being released without sufficient testing??? I no longer want to install updates.
I have 45 devices on it today and everything is fine, none are offline! I haven’t had any problems with this version so far! I will test it further, including compatibility with third-party devices! I have 450 devices available for testing!
How is this possible? My ZB devices are disappearing (appr. after 20 hrs) and a few come back online with their part number. I reconnected them all and the same thing happened again (after appr. 20 hrs). When I check my scenes it displays “device deleted”.
The ZB-Bridge U is not disappearing and all my WiFi devices are ok. Just the ZB devices connected to the ZB Bridge U after the update to 1.20.
Strange that other users don’t have this problem apparently.
PS: I must add that directly after the update everything was ok. It happened appr. 20 hrs later as already mentioned.
All my devices were added to ZBBridge Ultra in the previous version. I think I’ve been on version 20 for about 48 hours. Most of the devices I have are Tuyas, which work on the ZBBridge Ultra. I also have some Sonoff sensors and some ZBMinir2s connected to it, but I haven’t finished migrating everything to it to do a full test yet. However, it’s working without any problems here. So far.